Ironhead A place to talk about Ironheads.

Temperature problem solved (Long post)

Old Aug 7, 2011 | 10:29 AM
  #1  
yellowstone kelly's Avatar
yellowstone kelly
Thread Starter
|
Tourer
15 Year Member
Liked
Loved
Community Favorite
Joined: Mar 2009
Posts: 406
Likes: 122
From: Iowa
Default Temperature problem solved (Long post)

I had a frustrating problem last week with my '82 Sporty. When cold, it would start and run fine for a few miles, but if I turned the bike off or it died on its own, it wouldn't restart. It would turn over well, but wouldn't start back up.

The first time it happened, I had no tools with me. But after sitting around for 30 minutes trying to get it running, it finally started back up and got me home. The next day, I loaded up some tools and went for another ride. I made a 20-mile circuit on some back roads and it ran fine. I got back into town and slowed for a stoplight, and it died on me and wouldn't restart.

First thing I did was pull a plug and check for spark, and I did have spark. In fact, the bike started running on just one cylinder. I shut it off, put the spark plug back in and tried to start it, but no joy. The service manual says "If it has spark, the ignition system is OK, look elsewhere".

So I pulled the air cleaner off and verified the accelerator pump was squirting gas into the carb when I twisted the throttle. It did, so I had gas in the float bowl. I got a ride home to get my truck so I could haul it home. Got back to the bike and tried to start it one more time, and of course, it started up and I made it the five miles home again with no problems.

I did some troubleshooting for a couple days, including tearing into the carb to make sure nothing was getting plugged up with grit or garbage in the float bowl (been there, done that before). All looked OK in the carb.

I finally determined that when cold, the spark would jump the full 3/16 of an inch that the manual said it should. When hot, I still had spark, but it would barely jump 1/16 of an inch. So I bought a new coil, and the problem was solved. I knew the instant I hit the starter button, as it started immediately on the first revolution of the engine, like it always has. And it's run fine since then.

So, what I learned from this little exercise, is: 1. Not all spark is "good enough" spark. 2. Pay attention to the details. If the manual says 3/16 of an inch, make sure it works at 3/16 of an inch. 3. Replacment coil from my local indie is $65. 4. Intermittent problems are always a pain in the rear end, but it feels good when you finally get them fixed.

Safe riding to you all.

Mitch
 

Last edited by yellowstone kelly; Aug 7, 2011 at 10:41 AM.
Reply
Old Aug 7, 2011 | 03:24 PM
  #2  
scottfisher's Avatar
scottfisher
Road Captain
Joined: Oct 2010
Posts: 566
Likes: 3
From: rural ontario
Default

glad to hear you have solved your issue
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mvoss76
Touring Models
9
Aug 31, 2017 08:46 AM
shoemaker
EVO
8
Apr 17, 2013 07:55 PM
TOMMY1969
Shovelhead
15
Apr 12, 2011 05:20 PM
Slider 51 Pan
General Topics/Tech Tips
2
Jul 5, 2009 05:00 AM
1986FXST
EVO
20
Nov 19, 2008 11:12 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 02:26 AM.

story-0
7 Surprising Harley-Davidson Products that Are Not Motorcycles

Slideshow: The bar-and-shield logo shows up on far more than motorcycles, some of the company's most unexpected products have nothing to do with riding.

By Verdad Gallardo | 2026-04-29 16:50:35


VIEW MORE
story-1
8 Best Harley-Davidson Motorcycles Ever

Slideshow: Not every Harley gets it right, but these are the ones that genuinely earned their reputation.

By Pouria Savadkouei | 2026-04-15 14:23:21


VIEW MORE
story-2
10 Worst Harley-Davidson Motorcycles Ever

Slideshow: From the troubled AMF years to modern misfires, these bikes earned reputations for reliability issues, questionable engineering, or disappointing performance.

By Pouria Savadkouei | 2026-04-01 20:01:09


VIEW MORE
story-3
Killer Custom's Jail Break Is The Breakout That Refused to Blend In

Slideshow: Killer Custom's "Jail Breaker" build focuses more on stance and visual aggression than mechanical overhaul.

By Verdad Gallardo | 2026-03-18 19:20:32


VIEW MORE
story-4
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?

Slideshow: The Swiss custom shop has taken a Harley Softail and stretched it into something so long and low that it looks closer to a rolling sculpture than a conventional motorcycle.

By Verdad Gallardo | 2026-03-07 16:15:30


VIEW MORE
story-5
Harley-Davidson Reveals Super Cool Cafe Racer Concept

Slideshow: Harley-Davidson's new RMCR concept revives the café racer formula with modern hardware-and it may be exactly the reset the company needs.

By Verdad Gallardo | 2026-03-04 12:23:37


VIEW MORE
story-6
Engraved Rebellion: Inside Bundnerbike's Glam Rock II

Slideshow: A standard cruiser becomes an intricate metal canvas in the hands of a Swiss custom house known for pushing Harley-Davidson platforms far beyond their factory brief.

By Verdad Gallardo | 2026-02-24 18:19:44


VIEW MORE
story-7
10 Motorcycles You Should Never Buy

Slideshow: There is no shortage of great motorcycles to buy, but we would avoid these ten.

By Joe Kucinski | 2026-02-19 14:50:51


VIEW MORE
story-8
10 Things Harley-Davidson Needs to Fix in 2026

Slideshow: Harley-Davidson's challenges aren't abstract; they show up in dropping shipments, shrinking dealer traffic, and strategic decisions that aren't yet translating into growth.

By Verdad Gallardo | 2026-01-13 18:33:17


VIEW MORE
story-9
Southpaw Super Glide: A Left-Hand-Drive 1979 Harley FXE Built to Fit the Rider

Slideshow: Graeme Billington's left-hand-drive Shovelhead is as much about problem-solving as it is about classic Harley form.

By Verdad Gallardo | 2025-12-30 11:27:08


VIEW MORE