79 Shovel Help

Reply Subscribe

Thread Tools

Search this Thread

Apr 1, 2010 | 11:55 PM

#11

FilthyLucre

Road Master

Joined: Jun 2008

Posts: 1,078

Likes: 39

From: NW Florida

You should have started a new post rather then tag on to this old one. You may be correct that it is hitting the seal. It should be recessed slightly below the case opening. Also the flat side of the sprocket goes to the outside.

Apr 2, 2010 | 09:51 AM

#12

FLYING

Club Member

Joined: Dec 2009

Posts: 802

Likes: 3

From: Wisconsin

The Good thing is parts & Manuals are around for the shovels,so as long as you get a factory manual which is much better than the others you should have no problems!

Apr 2, 2010 | 02:16 PM

#13

arturo

4th Gear

Joined: Mar 2008

Posts: 8

Likes: 0

From: Maexico

tks partners..but I had done everithing (Clymer and Hannes manual) the only different that I had done is to change the main drive bearings (not pins)..the sleeves has a "key" I have to install or not?

Apr 6, 2010 | 02:43 AM

#14

bcshovel

2nd Gear

Joined: Mar 2010

Posts: 6

Likes: 0

From: Derby City

As for the frame, If memory serves me (which at my age it sometines doesn't) pre 1970 didn't have a number. the vin on the engine will tell you everything about it. If you need to know anything about your bike they will steer you in the right direction there.

Last edited by GeorgiaGirl; Apr 7, 2010 at 01:40 PM. Reason: No linking to other forums that compete with this one for membership