CV carb support Bracket
Thread Starter
|
Road Warrior
Joined: Sep 2007
Posts: 1,252
Likes: 142
CV carb support Bracket
I have a 74 shovelhead that I have redone the top end. I put on the CV carb a velocity stack that adds considerable weight. Can some one recommend some kind of support bracket that will work with this set up. There are what appears to be mounting holes on the bottom of the rocker boxes between the tubes that appear to be mounting place.
randy
randy
Seasoned HDF Member
Joined: Nov 2006
Posts: 12,878
Likes: 5,449
From: la la land jerzey
your bottom bolt on the manifold could attach to the center bolt on the engine block with a bracket they sell that is adjustable, for different lengths between the 2 connections -- johnjzjz
Thread Starter
|
Road Warrior
Joined: Sep 2007
Posts: 1,252
Likes: 142
I was thinking of something like that but wasn't too keen on loosening that engine block bolt incase it cracked the seal, but then again I think that is where it would make sence to put it. Who sells them, im in Ontario Canada? Thanks
randy
randy
Seasoned HDF Member
Joined: Nov 2006
Posts: 12,878
Likes: 5,449
From: la la land jerzey
V twin i believe has them and everyone had sold them in the past its what is done from the original chopper days foward when changing out to any carb - early shovels had a bracket off the front head underneath to the air filter it also held the choke cable bendix and keihin carbs - johnjzjz
Seasoned HDF Member
Joined: Oct 2005
Posts: 7,495
Likes: 3,705
From: Santa Klaus County, Cali
Nice looking motor you have there. Stock? modified? what gasket material did you use?
Club Member
Joined: Mar 2009
Posts: 66,110
Likes: 51,396
From: Niles Canyon Ca.
S&S used to and I think any big supplier like Custom Chrome or Drag Spec. should still carry them .
Thread
Thread Starter
Forum
Replies
Last Post
