My ride has GMA custom handlebar controls. I've had them all apart and there is no place for a switch to activate the brake light. So I figure I'll just put a pressure switch in. Problem is, there is no banjo fittings to put a banjo bolt switch in and the front brake line is all one piece. Any cost effective ideas?
Cleanest way to do it, is to mount a rear brake junction block under the lower triple tree....use a 2 piece front brake line and a regular pressure switch.
they make a front brake switch that is the banjo bolt at the same time - it has 2 small thin wires that come out the front and can be brought back into the switch housing -- i dont have a picture of it, i have them in stock and will do one tomorrow if you want - jz