Next mod for you all is a cam. I recommend a Woods Brothers TW-6 cam. It is a basic cam for the 1500-3500 rpm ranges and you dont have to do major engine work for its installation. However, if you decide to do some more later on you can still keep the same cam too. I have basically the same build, V&H BSS w/ BCTM Baffles, K&N on a Kuryakyn Hypercharger, PC III and this cam and was just dynoed at 90 HP and 92 TQ.

Good luck, ride safe.

 

Should of got shortys with them forward controls.. ull be hitten the pipe on hard and low rights..

And so should I have :P

 

..did you try to tighten two screws on back of mirror?
Later