How Do I....
Road Captain
Joined: Jun 2007
Posts: 734
Likes: 1
From: Nova Scotia
RE: How Do I....
Chunderboy, here is a pic using the nuts. I tried the nuts first to see if I liked it, but didn't. I'll try to get one with the spacer.
[IMG]local://upfiles/34486/71EB90357D884517A18818B492535F85.jpg[/IMG]
[IMG]local://upfiles/34486/71EB90357D884517A18818B492535F85.jpg[/IMG]
Elite HDF Member
Joined: Jul 2007
Posts: 3,891
Likes: 54
From: Mansfield, MA
RE: How Do I....
I already had the tank off, and I'm telephone wiring guy by trade.so I knew a few tricks and knots to get the harness through the bars. ..Not including the clutch cable, because the bike was on a jack and I couldn't drain the transmission, it took me about two hours. I've changed out bars a couple times
Starting from scratch including draining the tank it's about a 4-6 job...Take your time, take pics, and write down the pin codes when you remove them from the connectors.
Starting from scratch including draining the tank it's about a 4-6 job...Take your time, take pics, and write down the pin codes when you remove them from the connectors.
Elite HDF Member
Joined: Jul 2007
Posts: 3,891
Likes: 54
From: Mansfield, MA
RE: How Do I....
ORIGINAL: chunderboy
hspring03,
Not how long did it take to do the bars, just to do the lights? Sry for the confusion.
hspring03,
Not how long did it take to do the bars, just to do the lights? Sry for the confusion.
If you cut and splice the existing wires it's a 20 minute job.
That kit comes with new wiring and connectors, but of course it's under the tank..
Thread
Thread Starter
Forum
Replies
Last Post
ourjets1
General Topics/Tech Tips
0
Jul 27, 2012 02:56 PM
