Tach bracket
Thread Starter
|
Cruiser
Joined: Apr 2009
Posts: 170
Likes: 0
From: Oakville, MO.
Tach bracket
Well, I did a search and it appears I'm not alone in needing a tach bracket that will bolt onto the bar clamps for my Rocker. So it looks like the fab route for me, unless anyone else can chime in with a solution. If not, anyone interested in me making one for their scoot as well?
Stellar HDF Member
Joined: Nov 2005
Posts: 2,272
Likes: 10
From: Orange VA
I share your pain. I had the same problem with my Springer. Lots of options for standard spread risers and bars. Springers are spread wider and obviously the Rocker's setup a unique as well.
Unless HD or some other aftermarket company decides to make one for the OEM Rocker bar/riser configuration, you may be out of luck for a bolt-on solution.
So you can...
1. Fab your own
2. Swap your OEM rocker bars and risers for standard risers and bars. Then options for a riser mount bracket are available.
3. Install an integrated tach/speedo in the dash.
4. Install a tach mounted in a different location. Some offer setups to mount on the fork tubes, off the side of a rocker box, and maybe some other areas.
Good luck. Post pics of whatever you end up with. Rocker folks will be interested as will the rest of us.
Unless HD or some other aftermarket company decides to make one for the OEM Rocker bar/riser configuration, you may be out of luck for a bolt-on solution.
So you can...
1. Fab your own
2. Swap your OEM rocker bars and risers for standard risers and bars. Then options for a riser mount bracket are available.
3. Install an integrated tach/speedo in the dash.
4. Install a tach mounted in a different location. Some offer setups to mount on the fork tubes, off the side of a rocker box, and maybe some other areas.
Good luck. Post pics of whatever you end up with. Rocker folks will be interested as will the rest of us.
Thread Starter
|
Cruiser
Joined: Apr 2009
Posts: 170
Likes: 0
From: Oakville, MO.
Will do, guys. I have a template made up, and I know a guy through my work that can waterjet it for me fairly cheap. I'm thinking of using stainless, that way I can polish it and have chrome finish without the added expense and trouble of chroming it. Just curious, but what is the bolt spread across on your Springer frontends?
Thread
Thread Starter
Forum
Replies
Last Post
