blow torch, 5 lb hammer, oh and tweezers....jk.....leike they all said, good advise especially picking up service manual

 

In addition to the tools in this thread, I suggest a 1/2 in. torque wrench. Nothing fancy, a beam style craftsmen will do, maybe $25. Also, if you want to to do it by the book, a smaller 3/8 in. torque wrench calibrated for in-lbs that will handle 90% of the torque tolerances specified in the service manual. I bought a nice one for around $80 a few years ago.

I highly suggest the following 2 tools:

Neck bearing adjustment tool for Springer

Rocker arm adjustment tool for Springer

They both can be found here:

https://www.aeincorporated.com/Kasta...ore&category=5