Power commander
Thread Starter
|
Road Captain
Joined: Aug 2009
Posts: 513
Likes: 0
From: Utah
Power commander
Has anyone installed one on a cross bones? I talked to a guy that said you had to remove the fasteners from the fuse block and leave it unsecured? I have the brawler seat on mine. Thanks in advance.
Road Master
Joined: Apr 2010
Posts: 831
Likes: 14
From: Delawere
Fuel moto told me I would need to take the fuse box top off and remove the fuse box mounting bracket on the new fat boy. I did not want to do that so I removed the ECM factory bracket and it fits great. If you do this there is the wire harness that runs under the rear fender and the ECM bracket also holds the wires up but I used a heavy duty zip tie from the wire harness ti the frame under the seat and it works great. With the factory ECM bracket out of the way the fit is great and alot more room to play with. Just another option.
Thread Starter
|
Road Captain
Joined: Aug 2009
Posts: 513
Likes: 0
From: Utah
Thanks coronerrpm I wondered about that. I read the installation instructions for the Fatboy and it says to remove the pcm bracket. It also says in the instructions that it wont fit the bones. I wondered if it was because of the seat arrangement.
Tourer
Joined: May 2008
Posts: 283
Likes: 2
From: San Antonio, TX
Here's a link to a posting of my PCIII install from a previous thread.
https://www.hdforums.com/forum/6235170-post8.html
https://www.hdforums.com/forum/6235170-post8.html
Thread
Thread Starter
Forum
Replies
Last Post
TORQUEY
General Harley Davidson Chat
11
Sep 20, 2010 07:03 PM
