copper washers?
Thread Starter
|
Road Master
Joined: May 2005
Posts: 1,101
Likes: 425
From: Pennsylvania
copper washers?
OK, the service manual says to install the banjo bolt with new steel/rubber washers, but the new brake lines come with copper washers.
These copper washers are fine for this in spite of the service manuals recommendations?
These copper washers are fine for this in spite of the service manuals recommendations?
Tourer
Joined: May 2009
Posts: 389
Likes: 1
From: Mount Morris Illinois
Automobiles use copper washers.Either one should be fine.
Hows the bar swap coming?Did you pull the tank?
I've been wanting to do this too,but I am a little unsure.
Hows the bar swap coming?Did you pull the tank?
I've been wanting to do this too,but I am a little unsure.
Last edited by WoodsHog; Aug 13, 2010 at 07:43 PM.
Thread Starter
|
Road Master
Joined: May 2005
Posts: 1,101
Likes: 425
From: Pennsylvania
The brake line was the last bit. It wasn't too bad for a newb like myself.
Ran into a couple issues, but folks on the forum helped a lot.
I'm glad I did it. Spaced the work out over a few nights rather than trying to tackle it all in one day.
I didn't have to completely remove the tank. Just took the bolts out and slid it back far enough
to get at the connections.
I'll post pics tomorrow
Last edited by chunks; Aug 13, 2010 at 11:39 PM.
Thread
Thread Starter
Forum
Replies
Last Post
riderideride
2014-2024 Touring Models
2
Jun 20, 2014 08:31 AM
