tuner suggestions
Thread Starter
|
Road Captain
Joined: Nov 2009
Posts: 672
Likes: 3
From: Swamp in Louisiana
tuner suggestions
I was running a TTS Master tune( one bike) on my dyna and had my 96 pulling hard and sounding great,,,,But the 2004 softy doest have o2 sensors so i cant do any vtunes runs,,,So i guessing i can only flash a canned map,,,,what would be the route to go,,,,screaming eagle so i can do a dyno or trust the map flash?
Grand HDF Member
Joined: May 2008
Posts: 4,624
Likes: 189
From: Newcastle, Ca.
You can add 02's and change out the ECM on the 04 to an 05 or 06 ecm then use vtune. Or find a tuner that is familiar with TTS and have them dyno tune it. Or find a map - cheapest and easiest rout obviously. Sounds like you are experienced with vtune so if the canned map does not work out I would research the 02's and ecm. No need to buy another system imo.
If your bike is stage 1 and the map source is legitimate, ie TTS, and mapped for your bikes setup it should work fine.
If your bike is stage 1 and the map source is legitimate, ie TTS, and mapped for your bikes setup it should work fine.
Last edited by KumaRide; Feb 19, 2011 at 08:54 PM.
Thread Starter
|
Road Captain
Joined: Nov 2009
Posts: 672
Likes: 3
From: Swamp in Louisiana
Thanks Kuma,,,,I was just digging though ebay for a ECM,,,and also checked out the zipper auto tunes,,,,,I would prefer to change out the ECM,,,,so i can adjust when ever i want with out having to go through the whole commercial process,,,,of a dyno,,,
Cruiser
Joined: Nov 2009
Posts: 139
Likes: 1
From: Southern California
I used a TTS Mastertune on my 2004 Fatboy. The tuner removed my pipes welded in some O2 sensor bungs. He added his own wide ban sensors, put the bike on the dyno, built the custom map and then removed his wide ban O2 sensors and capped the bung holes. The bike runs awesome. It cost about $200 to get the pipes modified.
Thread
Thread Starter
Forum
Replies
Last Post
BlackBastard
Ignition/Tuner/ECM/Fuel Injection
7
Apr 13, 2016 06:44 PM
