Micro Fuel Moto wiring ?
Thread Starter
|
Road Master
Joined: Apr 2007
Posts: 769
Likes: 3
From: Ohio
Micro Fuel Moto wiring ?
I purchased the Micro Fuel moto Tuner for my 2013 Softail Slim and it came in this week and I'm installing today.
I have one question in the instructions for the TPS Sensor it says to connect to the GREY/PURPLE wire or position "C" , well I don't have the GREY/PURPLE wire, I have a GN/V wire.
What I am showing in the 2013 Softail Schematic for the Slim are position "1" 5v sensor power R/W, position "2" 5v sensor ground BK/W, and position "3" TPS GN/V, I'm betting it connects to the postion"3" TPS GN/V.
What I'm assuming is that 1 is A, 2 is B and 3 is C.
I sent an email to Fuel Moto but there may not be anyone in there today, so I thought I would post here and see if anyone is thinking the same as I am on this.
Seems like it would be a no-brainer for 1 to = A, 2 would = B, and 3 would = C.
But I could be wrong.
I have one question in the instructions for the TPS Sensor it says to connect to the GREY/PURPLE wire or position "C" , well I don't have the GREY/PURPLE wire, I have a GN/V wire.
What I am showing in the 2013 Softail Schematic for the Slim are position "1" 5v sensor power R/W, position "2" 5v sensor ground BK/W, and position "3" TPS GN/V, I'm betting it connects to the postion"3" TPS GN/V.
What I'm assuming is that 1 is A, 2 is B and 3 is C.
I sent an email to Fuel Moto but there may not be anyone in there today, so I thought I would post here and see if anyone is thinking the same as I am on this.
Seems like it would be a no-brainer for 1 to = A, 2 would = B, and 3 would = C.
But I could be wrong.
Last edited by oldwarrior; Aug 31, 2013 at 03:37 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Cliddle27
Ignition/Tuner/ECM/Fuel Injection
7
Nov 2, 2014 10:22 AM
