2000 1200 Custom, Warm running issues need help
Thread Starter
|
3rd Gear
Joined: Mar 2018
Posts: 7
Likes: 1
From: Glencoe, AL
Front intake seal is leaking, now I am TRYING to get the intake bolts out. The heads are rusted and will not budge. Been soaking them in PB Blaster everyday will try them again Wednesday evening, it will be the first time I have this week.
Road Warrior
Joined: Sep 2017
Posts: 1,609
Likes: 694
From: over the mountain
Front intake seal is leaking, now I am TRYING to get the intake bolts out. The heads are rusted and will not budge. Been soaking them in PB Blaster everyday will try them again Wednesday evening, it will be the first time I have this week.
Road Warrior
Joined: Sep 2017
Posts: 1,609
Likes: 694
From: over the mountain
His update...Front intake seal is leaking, now I am TRYING to get the intake bolts out. The heads are rusted and will not budge. Been soaking them in PB Blaster everyday will try them again Wednesday evening, it will be the first time I have this week.
My response in an earlier post.
"Yes if he had to pull the chock all the way out to make it run he is way lean. Pulling the chock out makes it way rich. Sounds like too much air from the manifold seals."
No sense in you digging any deeper than you already are. LOL
My response in an earlier post.
"Yes if he had to pull the chock all the way out to make it run he is way lean. Pulling the chock out makes it way rich. Sounds like too much air from the manifold seals."
No sense in you digging any deeper than you already are. LOL
Last edited by apache snow; Mar 28, 2018 at 08:46 AM.
Thread
Thread Starter
Forum
Replies
Last Post
