QUICK help needed
Thread Starter
|
Tourer
Joined: Aug 2007
Posts: 366
Likes: 0
From: Kalamazoo, MI
QUICK help needed
Long story short....my Nightster got bumped off phase 1 so I found a killer deal on 2007. Im picking it up tomorrow. I have V&H short shots waiting to go on it. The bike is stock right now....do I NEED to tweak the stock map if I'm only running the new pipes? Im ordering the Power Commander and a new air filter this week...I just happened on this bike so I don't have all of it yet but I still want to throw my pipes on. The bike is already broken in and just had the 1k service done.
Thanks.
Thanks.
Thread Starter
|
Tourer
Joined: Aug 2007
Posts: 366
Likes: 0
From: Kalamazoo, MI
RE: QUICK help needed
ORIGINAL: jeramy
you should be able to run the slipons without needing to tweek the map.but make sure you do when you install the air cleaner
you should be able to run the slipons without needing to tweek the map.but make sure you do when you install the air cleaner
These are actually full pipes. But leaving the stock A/C on, I'm hoping they aren't going to flow enough to lean the engine out.
Outstanding HDF Member
Joined: May 2005
Posts: 3,146
Likes: 50
From: A barrier island in NJ
RE: QUICK help needed
Full V&H Short Shots pipes on a 2007 could be a problem because of the EFI. The injection system's oxygen sensor is in the exhaust pipe not too far from the cylinder (front, I believe)...
Thread
Thread Starter
Forum
Replies
Last Post
