handlebars / cables question
Thread Starter
|
Tourer
Joined: Jun 2006
Posts: 309
Likes: 0
From: DALLAS TEXAS
handlebars / cables question
I have an 06 1200c. I want to change the stock bars to a set of Dyna mini apes. Can anyone tell me the cables they used to do this? It looks like the throttle and idle will work, but the clutch and brake line must be longer.
Road Warrior
Joined: Jan 2007
Posts: 1,688
Likes: 4
From: Crisfield, MD
Personal opinion...minis or any apes look better on shorter straight risers vs. the custom's tall pullback riser. And yes cables need to be swapped though re-routing will get ya some more length to work for the short term (I used my stock thottle idle cables for couple months and the housings cracked and I bent my brake line straight to fit too before changing all my cables).
I have the minis on 3" straight risers and am using 59" clutch, 38.75" throttle/idle, and 44" brake line all by Barnett and Russel. New vinyl calbles about +6" over will run ya around $75 and braided will cost $125-150.
I have the minis on 3" straight risers and am using 59" clutch, 38.75" throttle/idle, and 44" brake line all by Barnett and Russel. New vinyl calbles about +6" over will run ya around $75 and braided will cost $125-150.
Novice
Joined: Jan 2008
Posts: 19
Likes: 0
I just swapped to the Nightster bars and need shorter. Where you located? Want to trade and see if we match up?
Thread
Thread Starter
Forum
Replies
Last Post
