What am I doing wrong?
Road Warrior
Joined: May 2012
Posts: 1,988
Likes: 17
From: Between Fort Worth and Wichita Falls Texas
These puppies are the best $15 I ever spent.
Just noticed those are out of stock but has anodized ones too.
Just noticed those are out of stock but has anodized ones too.
Last edited by hogcowboy; Oct 28, 2014 at 09:00 AM.
Outstanding HDF Member
Joined: Jul 2010
Posts: 2,979
Likes: 57
From: PA
These puppies are the best $15 I ever spent.
Just noticed those are out of stock but Amazon has anodized ones too.
Just noticed those are out of stock but Amazon has anodized ones too.
Road Warrior
Joined: Nov 2013
Posts: 1,814
Likes: 11
From: USA
The HD valve stem hose comes with it's innards threaded in too far. Get a valve stem tool and turn the innards out about 3 turns and it will work like a champ.
Out of the package the innards will not compress the inside of the stem enough to allow air to enter the tire.
Out of the package the innards will not compress the inside of the stem enough to allow air to enter the tire.
Road Warrior
Joined: Oct 2007
Posts: 1,468
Likes: 4
From: South Carolina
accu gage EZ air. A real time saver.
use the EZ air to check the pressure and fill with an air hose if needed.
you know if you roll the bike until the air valve is below 8 and 5 oclock you can find it with your hands instead of wallering on the ground to look at it to check.
use the EZ air to check the pressure and fill with an air hose if needed.
you know if you roll the bike until the air valve is below 8 and 5 oclock you can find it with your hands instead of wallering on the ground to look at it to check.
Elite HDF Member
Joined: Jul 2007
Posts: 4,749
Likes: 16
From: sand mountain Alabama
I use this, works on all tire valves. A real problem solver.
http://www.gemplers.com/product/30A/...0141028192123s
Angled valve stems work good to. I have always used this, got mine at a station that closed in the 1970"s. The angled locking is all you may need. Just slide it on lock it and your done. You can add the rubber hose on most air chucks that screw off.
http://www.gemplers.com/product/30A/...0141028192123s
Angled valve stems work good to. I have always used this, got mine at a station that closed in the 1970"s. The angled locking is all you may need. Just slide it on lock it and your done. You can add the rubber hose on most air chucks that screw off.
Thread
Thread Starter
Forum
Replies
Last Post
Backdraft161
Tri Glide, RG3 & Freewheeler Models
5
Mar 3, 2018 06:52 AM
