Ok so I have done a lot of research on the efi to carb on a 2001 road king, people say they can’t find that harness u need for the carb model, well I found it very easy on amazon (namz model tho) for $116, they say is a plug and play and after studying my HD factory service manual looks like they are right, this conversion Gunna be a little easier than I thought, however! I’m Building a custom bike w this engine I am not running many parts and electrical parts on the bike, so here’s my question from the after market namz harness it plugs into the stock harness on the bike (7 wires) they go to......speedo, ground, indicator lamps, right hand control, and then 2 go to the tssm and at the tssm they go into the data link and ignition enable signal, well at this point Isant safe to say I do not need the tssm anymore? But what about the 2 wires that go into it? I’m guessing the the one that says ignition enable signal can be connected to my new turn key ignition?? And what about the data link wire that goes to the tssm??