I recently changed out the handlebars on my 19 road glide special I had to put on electrical extensions because I went to 14 inch bars after we got everything done we took it to the shop to have them flush the abs I picked it up today and rode,it home everything was working fine after I got home I adjust the bars slightly forward after which the left side controls stopped working we chased the wire and found power all the way to,the controls once we plugged the connector back in the controls started working at this point we thought all was well I go to test ride it and the engine light was on we are taking it back tomorrow see what the code says but was wondering if anyone had any ideas on what it might be

 

It's called..."that's not a proper intro to the forum." Need to take us around the block for a little spin before the pants come off w/assistance. >.<

 

I had to read this 3 times while enjoying my coffee, realizing there is not one period and two "mistake" comas. I don't want to be the grammar police and stating an introduction would be proper.

Welcome to the forum.

Ride safe!

 

Welcome to the Forum from Utah.

Here's a link that will show you how to check codes.

https://www.fuelmotousa.com/p-29661-...es.html#pcodes

 

It is not that hard to read......

Probably that left side control pack that always goes out.....