Delphi air cleaner mounting pattern...
Thread Starter
|
2nd Gear
Joined: Sep 2017
Posts: 6
Likes: 0
From: Texas
Delphi air cleaner mounting pattern...
Hey, y'all...not really new here, but I'm posting in the Touring forum on behalf of a brother.
Anyhow, here's the deal. I've got an old Sporty that I made a custom air cleaner pipe for with my 3D printer. Brother from another chapter wants me to make one for his 2010 Street Glide, but the mounting pattern to bolt it up to that throttle body is obviously a bit different than the Mikuni on my bike.
If anyone has a blueprint showing X and Y coordinates of the three air cleaner mounting holes from center of the throttle body bore, it would be greatly appreciated.
Thanks in advance.
Anyhow, here's the deal. I've got an old Sporty that I made a custom air cleaner pipe for with my 3D printer. Brother from another chapter wants me to make one for his 2010 Street Glide, but the mounting pattern to bolt it up to that throttle body is obviously a bit different than the Mikuni on my bike.
If anyone has a blueprint showing X and Y coordinates of the three air cleaner mounting holes from center of the throttle body bore, it would be greatly appreciated.
Thanks in advance.
Road Master
Joined: Jul 2014
Posts: 1,064
Likes: 405
From: Cedar BC
You likely already know this, but If nobody has the dimensions on hand or sendable, the gasket may be available 29645-08 for a few bucks at the dealer.
Last edited by tfi racing; Jul 2, 2019 at 09:50 PM.
Thread Starter
|
2nd Gear
Joined: Sep 2017
Posts: 6
Likes: 0
From: Texas
Yeah, that would likely work, but it would also require me to measure stuff...
Thread
Thread Starter
Forum
Replies
Last Post
