cams are installed thanks for the help
Thread Starter
|
Intermediate
Joined: Mar 2007
Posts: 31
Likes: 0
From:
cams are installed thanks for the help
Just finished the gear drive cam install. I would not have tried to do this job without reading the experience that other people had. Thanks to Dawg for the tip about Gary's bearing tool. Tater did a write up about his install, good to read. And there are other posts that helped. Thanks to all...
Extreme HDF Member
Joined: Apr 2006
Posts: 10,449
Likes: 46
From: Roswell, GA
RE: cams are installed thanks for the help
grandad: Congrats on the DIY gear drive cam install.
dcfatboy: Congrats on your build and thanks for posting an SAE corrected, smoothing 5 chart-bet it's a blast to ride.
dcfatboy: Congrats on your build and thanks for posting an SAE corrected, smoothing 5 chart-bet it's a blast to ride.
RE: cams are installed thanks for the help
ORIGINAL: granddad
Just finished the gear drive cam install. I would not have tried to do this job without reading the experience that other people had. Thanks to Dawg for the tip about Gary's bearing tool. Tater did a write up about his install, good to read. And there are other posts that helped. Thanks to all...
Just finished the gear drive cam install. I would not have tried to do this job without reading the experience that other people had. Thanks to Dawg for the tip about Gary's bearing tool. Tater did a write up about his install, good to read. And there are other posts that helped. Thanks to all...
Tourer
Joined: Jan 2006
Posts: 373
Likes: 26
From: Virginia
RE: cams are installed thanks for the help
ORIGINAL: Harleypingman
dcfatboy: Congrats on your build and thanks for posting an SAE corrected, smoothing 5 chart-bet it's a blast to ride.
dcfatboy: Congrats on your build and thanks for posting an SAE corrected, smoothing 5 chart-bet it's a blast to ride.
The dyno is with Rush mufflers with 2.5" baffles. I now have 2.0" baffles and notice a big difference with my seat-of-the-pants dyno. I will probably have a new dyno in about 3 weeks.
This is my build: [ul][*]AMS 96" BB, Heads and Lifters[*]Cometic .040 head gasket[*]Andrews 26G cams[*]Bassani Tru-Duals[*]Rush Slash Down mufflers (2.5" baffles)[*]Arlen Ness Big Sucker[*]Power Commander with Rev X-tend[*]84.43 HP, 97.71 TQ (5th gear)[/ul]
Thread
Thread Starter
Forum
Replies
Last Post
wrustywrench
Touring Models
1
May 17, 2007 12:35 PM
