SE quick install push rods
Thread Starter
|
Advanced
Joined: Jun 2007
Posts: 69
Likes: 0
From:
SE quick install push rods
Okay I just got one push rod in and adjusted out, but! the push rod isn't even near the rocker, I mean it seams like they are short, even though I know their not, is this normal? Will the lifters eventually pump up to a point where they will make the rod always be in contact with the lifter and the rocker arm? Yes my first time
Tourer
Joined: Mar 2007
Posts: 322
Likes: 0
From: Chicago
RE: SE quick install push rods
They should not be loose, they should touch the lifter and rocker then turn one full turn. I forget if one is longer then the other or just wider. Double check everything, there should be no gaps.
Intermediate
Joined: Mar 2007
Posts: 31
Likes: 0
From:
RE: SE quick install push rods
The pushrods are different lenghts. you also have to get the cams at theirlowest point of lift to properly adjust the pushrods. I think the intake pushrod is shorter. good luck
Thread Starter
|
Advanced
Joined: Jun 2007
Posts: 69
Likes: 0
From:
RE: SE quick install push rods
Yeah dawg and tatergog gave me some good advice and I home free, I had over the last few years done some rounds of chemo and sometimes I just cant focus and think right, or I can think of something but cant say it, weird huh? anyway where the pushrods are concerned I just didn't connect with lengthing them so they were snug on the lifter and the rocker arm, then drive them out 2 1/2 turns.. But its done! My wife and neighbors are gonna be mad........LOUD!
Thread
Thread Starter
Forum
Replies
Last Post
rbartick
Touring Models
5
May 27, 2010 12:38 AM
adjust, eagle, evo, harleys, install, installation, instructions, job, motorcycle, push, pushrods, quick, quickinstall, rods, screaming, se
