FLTR Headlight Adjustment
Thread Starter
|
Road Warrior
Joined: May 2006
Posts: 1,276
Likes: 0
From: Top of Texas
FLTR Headlight Adjustment
Have my measurements laid out, cross target on wall, $4.5MM$ deep-well socket and repair manual in hand. I need to adjust the heigth of both beams, they are too low. Do I actually have to turn both the left and right adjusters simataneously to accomplish this?
I tried to search but no luck...Any help would be greatly appreciated....
I tried to search but no luck...Any help would be greatly appreciated....
Thread Starter
|
Road Warrior
Joined: May 2006
Posts: 1,276
Likes: 0
From: Top of Texas
Tried seperate adjustment - nothing. The dealer in Amarillo had the fairing off ~ 3 weeks ago to chase the cruise wiring (check engine light) and I think the mechanic dinked something up. The entire assembly moves; it was clear he had never worked on an FLTR. Looks like another AM ride w/ the high beams until I can get it in.
Ultimate HDF Member
Joined: May 2006
Posts: 6,590
Likes: 444
From: Ohio
What I meant was that they do not need to be done simultaniously, but if you are not getting any movement something is wrong. There is a HD service bulletin that gives a measurement for the adjusters with the fairing off. It is a good starting point. I am not home so I can't give it to you.
Thread
Thread Starter
Forum
Replies
Last Post
