Squeaky windshield on fairing
Thread Starter
|
Road Master
Joined: Sep 2007
Posts: 802
Likes: 3
From: Minnesota
Squeaky windshield on fairing
I have a stock windshield that came on my dragonfly fairing...and it squeaks pretty bad...anything I can do to put between the windshield on the front and back where the shield and fairing fiberglass meet...Or am I the only one that has had this issue
Road Master
Joined: May 2009
Posts: 827
Likes: 1
From: Covington, Ga.
Go to the hunting shop or to the sewing shop and get some sticky back felt.
Put it between the shield and the offending edge. Use a razor knife to CAREFULLY trim off the excess.
Problem solved, inconspicuous, cheap, fast.
.
Put it between the shield and the offending edge. Use a razor knife to CAREFULLY trim off the excess.
Problem solved, inconspicuous, cheap, fast.
.
Road Warrior
Joined: May 2009
Posts: 1,945
Likes: 4
From: Victoria, Australia
Bit of a mouthful but when you look at it it will make sense.
Road Master
Joined: Apr 2008
Posts: 1,034
Likes: 1
Had same problem with 04 EGC. I took an old note book backing and cut small strips, 1/2" wide and full length long and placed them en between the shield and rubber strip and problem gone. I just made sure the cardboard was down tad so as not to be seen. Did a buddys bike same way, but touched the edge of the cardboard with black felt tip marker to insure it would not be seen. It is free and you don't have to take the shield out for you just tuck it in and retighten it.
Thread
Thread Starter
Forum
Replies
Last Post
longrideshields-1
Motorcycle Parts For Sale-Misc. Parts
4
Jan 10, 2011 06:25 PM
