ultra docking hardware
Banned
Joined: Mar 2006
Posts: 8,603
Likes: 10
RE: ultra docking hardware
dont take out all the bolts...dont follow the instructions....look at the pics...decide which washers you need beforehand and do the fronts first...one side at a time....but DONT take the bolts out, loosen em but dont take em all out on both sides at once
Tourer
Joined: Aug 2006
Posts: 302
Likes: 16
From: Cedar Rapids, Iowa
RE: ultra docking hardware
Go off the pics! I just finished a 2007 Ultra Classic removable tour pak kit and the dealer sold me a kit that wasn't needed, but I had already opened it up. It's not that hard to do yourself.
Thread Starter
|
Tourer
Joined: Aug 2006
Posts: 480
Likes: 1
RE: ultra docking hardware
front and rear docking hardware installed, it wasn't as bad a job as I thought. The draw back is if I want to take the tour pac off You have disconnect all the wires and tuck them under the seat. When you reinstall the tourpac you have to reconnect everything. I plan on cutting the wires under the seat and installing connectors that I can unplug so when I remove the tourpac it will have the wiring still connected to it.
The antena wires are goining to be a pain I need to figure out a way I can splice them with some sort of connector and not loose any signal. Any Idears?
Thanks
Rick
The antena wires are goining to be a pain I need to figure out a way I can splice them with some sort of connector and not loose any signal. Any Idears?
Thanks
Rick
Thread
Thread Starter
Forum
Replies
Last Post
endress1
General Harley Davidson Chat
11
Oct 17, 2011 09:36 PM
