This the final install of my winter mods. Some of you may have read my earlier posts about my woods 7h cams install, and Jamie provided me with an exellent map..I was very happy with the results. However, I have purchased the AT-100 Auto Tune modules, to go with the PCV. Got it all installed yesterday, using Jamies map as a base, fired it up and went for a jaunt.. it didnt take long for me to realize a smoothing effect, much better transitions all through the range. I am very impressed, and pleased with the results. I must say money well spent..Theres my 2 cents worth, Scooter

 

Its great to hear how well you like the autotune, should be getting mine from Fuel Moto this next week then I can get my cams installed.

 

Auto Tune works great! Unfortunately, my tuner knew that and spent just less than an hour on the dyno! Said "...the auto tune will really dial it in from this point". Bike runs GREAT but, was looking for that 100/100 dyno sheet!

 

The auto does does work very well for me im impressed with my results also.

 

but I haven't seen or felt any real difference since I finally got the AT to work. Could be the map was so close as to make the trim value changes almost unperceivable. Didn't see any over 10 (except for 1) in the columns.