Hot start or vibration issues
Thread Starter
|
Road Master
Joined: May 2008
Posts: 1,096
Likes: 107
From: Joplin, MO
Hot start or vibration issues
Anybody having any of these issues with the andrews 21 or SE 203 cams? Have done cam research until I could puke, and am down to these two cams. Looking for some extremely low end torque on a TC88. I rarely get her up over 3000 rpm . HELP!
Elite HDF Member
Joined: Oct 2006
Posts: 4,128
Likes: 27
From: florida swamp
Go with the andrews 21 for low end torque.
I hope you at least get it over 3000 rpm when accelerating. If not, then don't complain about the bike not having any power because your babying it.
I hope you at least get it over 3000 rpm when accelerating. If not, then don't complain about the bike not having any power because your babying it.
Extreme HDF Member
Joined: Sep 2005
Posts: 11,615
Likes: 50
From: Baton Rouge, LA
The problem with your stock TC88 is the low compression (8.7) which will make it hard to maintain your low-end without a compression increase. I think a nice combo would be the TW48, the Andrews conversion kit, and a 95" BB kit that'll increase your compression to around 9.5.
Thread
Thread Starter
Forum
Replies
Last Post
coot34
Primary/Transmission/Driveline/Clutch
5
Sep 19, 2008 06:35 AM
