Help! Outer primary cover
Road Captain
Joined: Apr 2009
Posts: 728
Likes: 25
From: griffin ga
I would use caution on prying aging the sealing surface.. or sticking a blade inbetween both halves.. it may gouge the surface if it leaves a deep enough scratch it may leak of you may have to use sealer to fill the void..
Thread Starter
|
Tourer
Joined: Apr 2011
Posts: 269
Likes: 0
From: Randolph, WI
Yeayaa!! Got the cover off. Compensator installed. Made a wedge at work out of some stainless. Ground the end to a knife edge. Carefully worked it in from the top middle. Can't believe it worked. Thank you to all who helped. Much appreciated!
Seasoned HDF Member
Joined: Apr 2006
Posts: 10,675
Likes: 95
From: Billings,Mt.
Now you can sell them here!
MODERATOR
Joined: Oct 2007
Posts: 4,108
Likes: 1,964
From: New England
Before reassembling, make sure the comp bolt is torqued and the tensioner is adjusted up correctly with little to no slack in the chain.
Then make double sure the primary housing is very clean and free from any particles that might prevent a good primary cover seal.
Add fluid, button it up, and then ride!
Well done and good luck!
Then make double sure the primary housing is very clean and free from any particles that might prevent a good primary cover seal.
Add fluid, button it up, and then ride!
Well done and good luck!
Thread
Thread Starter
Forum
Replies
Last Post
kelton3
Sportster Models
2
May 1, 2008 03:36 PM
carguy9497
Primary/Transmission/Driveline/Clutch
6
Oct 7, 2006 11:45 PM
