Pegs install
Thread Starter
|
Road Warrior
Joined: Oct 2010
Posts: 1,862
Likes: 127
From: Republic of Texas
Pegs install
Am I missing something? Bought a set of HD Streamliner pegs to be used as highway pegs on my 2010 SG. I wanted to rotate the pegs to a better position. Can it be that the bolt that runs inside the pegs is a Metric hex? I couldn't find an SAE hex wrench that would fit. I don't have any Metric hex wrenches to try. Instruction sheet on HD parts site describes it as "Screw, hex socket head cap".
Extreme HDF Member
Joined: Jun 2007
Posts: 12,653
Likes: 18
From: Broken Arrow, Oklahoma
Am I missing something? Bought a set of HD Streamliner pegs to be used as highway pegs on my 2010 SG. I wanted to rotate the pegs to a better position. Can it be that the bolt that runs inside the pegs is a Metric hex? I couldn't find an SAE hex wrench that would fit. I don't have any Metric hex wrenches to try. Instruction sheet on HD parts site describes it as "Screw, hex socket head cap".
The bolt that goes thru the peg, from the end, is 1/4" SAE. At least on mine it is.
Outstanding HDF Member
Joined: Jan 2011
Posts: 2,590
Likes: 31
From: Western Illinois, land of bad roads, and corrupt politicians
Should be the same as your passenger pegs.
Thread Starter
|
Road Warrior
Joined: Oct 2010
Posts: 1,862
Likes: 127
From: Republic of Texas
I did buy them used so they must have been changed. The HD stock pegs come with a 1/4" hex screw. 1/4" SAE works perfect on my stock passenger pegs but it's too big for the ones I bought. And 7/32" SAE is too small. Someone must have replaced with a Metric. I don't have a set of Metric hex wrenches but I will at least have one tomorrow when I go to the hardware store.
Thread
Thread Starter
Forum
Replies
Last Post
AmericanMuscle
General Harley Davidson Chat
1
Sep 26, 2012 04:29 PM
