Stereo with no sound after Start
Thread Starter
|
Road Master
Joined: Aug 2008
Posts: 771
Likes: 0
From: Cincinnati
Stereo with no sound after Start
I have a kenwood KIV 700 with mini amp and hawg wired controls. For some reason lately it works greet with the accessory position but not in the ignition position. The stereo is on but no sound when starting the bike and sometimes will make a pop sound from the speakers when starting the bike. I can shut the bike off turn back to accessory and then back to ignition and start the bike and then it works.
So my question is this a bad signal or a bad ground issue ?
So my question is this a bad signal or a bad ground issue ?
Thread Starter
|
Road Master
Joined: Aug 2008
Posts: 771
Likes: 0
From: Cincinnati
I have the turn on wire hooked to the to a hot wire I found, not sure what its for but its hot all the time in either accessory or run position.
Thread
Thread Starter
Forum
Replies
Last Post
