blinking lights
Bike needs to be put into transport mode:
Turn the ignition to IGN
Set engine stop switch to off
With an assigned fob within range turn the ignition switch from IGN to Acc
Simultaneously press both the left and right turn signal switches. This must be done within 5 seconds of turning the ignition switch to ACC.
After the signals flash once, turn the ignition switch to OFF and the module is armed
Confirmation: Turn signal blinks 3 times when armed for one ignition cycle
Turn the ignition to IGN
Set engine stop switch to off
With an assigned fob within range turn the ignition switch from IGN to Acc
Simultaneously press both the left and right turn signal switches. This must be done within 5 seconds of turning the ignition switch to ACC.
After the signals flash once, turn the ignition switch to OFF and the module is armed
Confirmation: Turn signal blinks 3 times when armed for one ignition cycle
Road Master
Joined: Aug 2012
Posts: 1,008
Likes: 229
From: Saskatchewan
Putting the Security System into Transport Mode is covered in the manual as well as the online manual, Harley-Davidson Smart Security System. This will allow you to move the bike but activates the alarms if there is any attempt to start it.
Thread
Thread Starter
Forum
Replies
Last Post
