'07 107CI Street Bob Dyno and Drag N's
Thread Starter
|
Advanced
Joined: Jul 2006
Posts: 78
Likes: 0
'07 107CI Street Bob Dyno and Drag N's
Hi Guys,
First Map is of a completly stock '07 St Bob-no stage 1 or that. This was the base line
Second map is HP and the AFR line after the BB kit
Third map is the TQ map.
The dyno's where done in 4 gear.
The kit is: GMR 107 BB kit
GMR STG 2 heads
HP Inc 55mm TB
Andrews 55 Cams
D&D Fatcat 2-1
PC111 with O2 elimantors
Comp 10.5-1 Pistons
Numbers are 110HP and 112TQ
I believe that there is probably another 5 and 5 in this build/Tune. I cannot use SERT as there is only 1 Dynojet250i in my state and they will not use SERT. Only rear Cyclinder was used for the Dyno.
I went to the local drags in the evening after the tune and ran 5 times down the strip for a best of 12.15 at 180k/hr-113mph.
Very pleased with the build and it runs hard. Steve at GMR was excellent to deal with and as i'm in Australia, long way from help. Thanks again to Steve and Michelle.
karlrockdrain
First Map is of a completly stock '07 St Bob-no stage 1 or that. This was the base line
Second map is HP and the AFR line after the BB kit
Third map is the TQ map.
The dyno's where done in 4 gear.
The kit is: GMR 107 BB kit
GMR STG 2 heads
HP Inc 55mm TB
Andrews 55 Cams
D&D Fatcat 2-1
PC111 with O2 elimantors
Comp 10.5-1 Pistons
Numbers are 110HP and 112TQ
I believe that there is probably another 5 and 5 in this build/Tune. I cannot use SERT as there is only 1 Dynojet250i in my state and they will not use SERT. Only rear Cyclinder was used for the Dyno.
I went to the local drags in the evening after the tune and ran 5 times down the strip for a best of 12.15 at 180k/hr-113mph.
Very pleased with the build and it runs hard. Steve at GMR was excellent to deal with and as i'm in Australia, long way from help. Thanks again to Steve and Michelle.
karlrockdrain
Thread
Thread Starter
Forum
Replies
Last Post
superprohero
Ignition/Tuner/ECM/Fuel Injection
0
Apr 23, 2019 06:15 PM
