It looks like you kept the stud setup to mount the bars, is there a reason you didn't switch to bolts that could be lower profile and cleaner?

 

Well after some Mother's Day bike fitting, she's on board with going with a pullback MX bar setup. The stock mini-apes are 11" from the top of the tress and 34" at their widest point and I haven't been able to measure pullback yet. Doing the hand placement exercise, she needs narrower bars that are pulled back about 3" and about 10" high. I'm looking at the Thrashin 6.5" pullback risers and the Biltwell Tracker mid bends. That would get her 10" from the top of the tress, 30.25" total width and 4.5" of pullback. It'll depend on how much pullback the stock bars have to know what she'll gain, but I can tell that it's not 4.5", maybe 2.5"?

 

That was to hold the bar for that picture, I switched to bolts.

 

nice looking bar OldMike, how high and what brand is it ?

 

They are Biltwell.
I have the 10" bars, I'm 5'9" tall.

https://www.biltwellinc.com/products...ack-8-10-12-14

 

Thanks for the answer, I like the look but a bit too high for me, I wonder if I could find a 6" like this...

 

This brand, they have 8", No 6.
Remember this is total height not like buying a riser and bars.
Mine sell as 10" but are 9-1/2" at most.

 

At the handlebar axle it looks like it's closer to 8", so the 8" should be closer to 6"