Speedo reading wrong
Thread Starter
|
Club Member
Joined: Oct 2022
Posts: 652
Likes: 510
From: United Kingdom
Speedo reading wrong
Bit of a weird one this...
Did some work on the bike which involved removing the tank (I had to replace the fuel float system).
Followed the correct procedure for purging the fuel system and also the procedure with regards to removing the main fuse.
Did all the work, put everything back together again following the correct procedures including clearing the h codes.
However, now my Speedometer is reading fast - about 20-30mph faster than I'm actually going.
Everything was working fine prior to doing the work.
I've check the diagnostic codes and nothing showing (either current or historic)
Any ideas?
Is there a way to reset it?
Did some work on the bike which involved removing the tank (I had to replace the fuel float system).
Followed the correct procedure for purging the fuel system and also the procedure with regards to removing the main fuse.
Did all the work, put everything back together again following the correct procedures including clearing the h codes.
However, now my Speedometer is reading fast - about 20-30mph faster than I'm actually going.
Everything was working fine prior to doing the work.
I've check the diagnostic codes and nothing showing (either current or historic)
Any ideas?
Is there a way to reset it?
Stellar HDF Member
Joined: Aug 2011
Posts: 2,767
Likes: 1,802
From: Newnan, GA
Sussed it 
Listened to Revelator Alf's guidance and, at some point or another, I'd set the speedo to read in kph.
Listened to Revelator Alf's guidance and, at some point or another, I'd set the speedo to read in kph.
Thread
Thread Starter
Forum
Replies
Last Post
Shawnh71
Sportster Models
3
Aug 19, 2024 08:04 AM
