Basic settings
Thread Starter
|
Advanced
Joined: Mar 2020
Posts: 51
Likes: 3
From: Redondo beach
Basic settings
I installed a micro4v2 diamond 600w amp for GZ 7/10 in saddlebag, I have a DSR1 installed. I was questioning where all the settings to be set at the amp for basic set up. Sensitivity and frequency *****? Sensitivity 1.0v -0.2v. Frequency 40Hz-400Hz. The X-over will be set on flat. Also I will be bridging to 2 speakers.
Seasoned HDF Member
Joined: Jan 2013
Posts: 10,637
Likes: 1,246
From: Lake, Ms
Ok you'll need a 1000hz test tone and a digital multimeter to set your gains. HU 3 clicks from wide open volume (no speakers hooked up) adjust gains to a target value of 34 volts...on both sides of the amp. Leave the freq filter off or flat on the amp. You'll set freq's with the DSP.
I'd get the HU flashed as well and ditch the LL's. I'd recommend the Rockford flash.
I'd get the HU flashed as well and ditch the LL's. I'd recommend the Rockford flash.
Thread
Thread Starter
Forum
Replies
Last Post
