TPS Install
Thread Starter
|
Advanced
Joined: Sep 2017
Posts: 79
Likes: 1
From: Oceanside, California
TPS Install
Good evening,
I have an ‘06 Wide Glide. I’m planning on switching out my throttle position sensor soon (already got the part) and I’m wondering if other than putting the new sensor on and plugging it in if there’s anything else I have to do…
I read that there’s an initialization process that goes like: With the RUN / STOP switch in the run
position, switch the ignition switch to IGN for 30 seconds, then OFF 30 sec, repeat two more times. Does this sound correct? And if so, is that it?
Thanks in advance.
I have an ‘06 Wide Glide. I’m planning on switching out my throttle position sensor soon (already got the part) and I’m wondering if other than putting the new sensor on and plugging it in if there’s anything else I have to do…
I read that there’s an initialization process that goes like: With the RUN / STOP switch in the run
position, switch the ignition switch to IGN for 30 seconds, then OFF 30 sec, repeat two more times. Does this sound correct? And if so, is that it?
Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
