Taillight bracket
Cruiser
Joined: Oct 2009
Posts: 128
Likes: 4
From: South Carolina
If you are trying to access the taillight bulb, then you just unscrew those two phillips head screws holding the bracket onto the tail. Once you have done that just pull it off and it will hang by the wires of the brake bulb. Perhaps I'm not understanding what you are asking? I just replaced my bulbs on my 07 WG 3 days ago to LED so it was that easy.
Thread Starter
|
Advanced
Joined: Mar 2008
Posts: 59
Likes: 0
From:
If you are trying to access the taillight bulb, then you just unscrew those two phillips head screws holding the bracket onto the tail. Once you have done that just pull it off and it will hang by the wires of the brake bulb. Perhaps I'm not understanding what you are asking? I just replaced my bulbs on my 07 WG 3 days ago to LED so it was that easy.
Last edited by pinoy; Jan 30, 2010 at 01:38 PM.
Cruiser
Joined: Jul 2008
Posts: 147
Likes: 1
From: Loganville Georgia
the bolts run through the fender, fender struts, and fender strut chrome covers that hold the taillight onto the rear of the bike. the turn signals run through it as well. you will have to cut the turn signals to remove the plastic tail lamp assembly. Its aggravating that they couldn't of thought of a way to just simply plug the turn signals in, enstead of having to cut them. There is also electrical wiring running underneath the top portion of the rear fender also. it unplugs from the tail lamp assembly at least. Hey were did you get that round sissy bar? I've been looking for one. Cyclevisions has a 18 incher but thats just too tall for me.
Thread Starter
|
Advanced
Joined: Mar 2008
Posts: 59
Likes: 0
From:
Thanks a lot elevenbravo78!!,i bought that sissybar here in Sweden,
Just look for:
http://www.khromewerks.com/index.htm
Just look for:
http://www.khromewerks.com/index.htm
Last edited by pinoy; Jan 29, 2010 at 02:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
