Dyna Batwing wind management
Grand HDF Member
Joined: May 2007
Posts: 3,553
Likes: 17
No my headlight is a 5.75" x 9" model from Eastern Performance. Have it on an offset mount to push it up and out a little further. Still sits inside the fairing a bit but not too bad where it looks odd.
Tourer
Joined: Nov 2009
Posts: 499
Likes: 1
From: Locust Grove, VA
I think I've seen on here (it has been a while) where some Dyna riders adapted the Front Fork Air Baffle made for the Touring models ....
The adaptation involves cutting off the upright section (along the red line in the photo below) and drilling a hole centered just aft of the leading edge (represented by the red dot) ... I am not certain, but, I also seem to recall that either edge may need to be radiused to clear the fork tubes (might depend on which front end, narrow-, mid- or wide-glide) ....
I have not ridden a bike with this baffle ... so, have no opinion to offer ... thought I'd put it out there for anyone interested ....
R/
'Chop
The adaptation involves cutting off the upright section (along the red line in the photo below) and drilling a hole centered just aft of the leading edge (represented by the red dot) ... I am not certain, but, I also seem to recall that either edge may need to be radiused to clear the fork tubes (might depend on which front end, narrow-, mid- or wide-glide) ....
I have not ridden a bike with this baffle ... so, have no opinion to offer ... thought I'd put it out there for anyone interested ....
R/
'Chop
I found that you can get this same Air Baffle in black. Part #58520-79B.
Cruiser
Joined: Apr 2009
Posts: 175
Likes: 0
From: NYC
I figured I'd jump in...
I actually just purchased a MS Batwing with deflectors for my 07 FXDB moments ago. I stumbled across bikerhaven.net and decided that the "kit" option was unbeatable so I spent the 400 buckaroos. I already have a 14" compact shield from H-D, but find unbearable for long trips; the buffeting gets very intense. Prior to making this purchase I figured that complimenting my 14" shield with MS lowers would cure most of the buffeting, but it definitely didn't. So now I have the complete arsenal from MS for my bob, and I hope it pays off. Essentially, I want to ride in complete comfort. Also, I got a 7" visor so hopefully that would be enough to redirect the air flow over my helmet.
I actually just purchased a MS Batwing with deflectors for my 07 FXDB moments ago. I stumbled across bikerhaven.net and decided that the "kit" option was unbeatable so I spent the 400 buckaroos. I already have a 14" compact shield from H-D, but find unbearable for long trips; the buffeting gets very intense. Prior to making this purchase I figured that complimenting my 14" shield with MS lowers would cure most of the buffeting, but it definitely didn't. So now I have the complete arsenal from MS for my bob, and I hope it pays off. Essentially, I want to ride in complete comfort. Also, I got a 7" visor so hopefully that would be enough to redirect the air flow over my helmet.
Elite HDF Member
Joined: Apr 2007
Posts: 4,919
Likes: 23
From: Seattle, WA
... perhaps he'll chime in on his experience ....
Mascman ...? ... what say ...?
R/
'Chop
Cruiser
Joined: Jul 2009
Posts: 242
Likes: 0
New windshield from National Cycle. I needed more coverage for my upper body and this shield REALLY flows the air around me. Of course, I had to be the poser and paint like a harley bat-wing fairing. Flat black from the inside shown through as gloss from the front. Its a little on the tall side, but so am I...6'4" with most all my height in my upper body. It may be painted a little high in the center, Will probably clean paint down a little and square it off a little lower...flat across the middle. This windshield REALLY makes my bike much more stable at a higher speed. Normally my comfort zone w/o a shield tops out at @50 mph. But I'm on Hwy 70 twice a day and with the original HD windshield , my comfort zone is @75. With this shield, 90 is more comfy than 75 with the other one. I shot up to 90 yesterday without really paying attention, backed up to 72 and was in real comfort!!
Road Warrior
Joined: May 2011
Posts: 1,396
Likes: 7
From: Connecticut :(
looked in a bike magazine at the store, I saw the Memphis Shades makes a NEW style bat wing for dynas, I put the mg back on the rack and looked on the website, its not there yet tho... Maybe call them and they can email you the specs and pics, looked nice in the ad they put in the magazine...
HD Forum Stories
The Best of Harley-Davidson for Lifelong Riders
6 Weirdest Harley-Davidsons Ever Sold to the Public
Verdad Gallardo
7 Times Harley-Davidson Chucked Tradition Out the Window
Verdad Gallardo
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Verdad Gallardo
8 Best Harley-Davidson Motorcycles Ever
Pouria Savadkouei
10 Worst Harley-Davidson Motorcycles Ever
Pouria Savadkouei
Killer Custom's Jail Break Is The Breakout That Refused to Blend In
Verdad Gallardo
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Verdad Gallardo
Harley-Davidson Reveals Super Cool Cafe Racer Concept
Verdad Gallardo
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Verdad Gallardo
Road Captain
Joined: Jun 2007
Posts: 644
Likes: 5
looked in a bike magazine at the store, I saw the Memphis Shades makes a NEW style bat wing for dynas, I put the mg back on the rack and looked on the website, its not there yet tho... Maybe call them and they can email you the specs and pics, looked nice in the ad they put in the magazine...
Last edited by expy; Jul 12, 2011 at 08:01 AM.
Road Warrior
Joined: Aug 2009
Posts: 1,443
Likes: 3
From: Northwest Georgia
That looks great. Any issues with the handlebar mounted speedo being in the way? Do you have photos from the cockpit side?
That headlight looks kind of 'buried' in there. Does it still light the road as well?
That headlight looks kind of 'buried' in there. Does it still light the road as well?
