Relocating Turn Signal
Thread Starter
|
Intermediate
Joined: Mar 2011
Posts: 41
Likes: 0
Relocating Turn Signal
Getting ready to move the signals from the bars to the forks. I bought the kit from Harley. Does anyone have a how to on how to do this any help appreciated. Thanks in Advance
Elite HDF Member
Joined: Feb 2008
Posts: 4,606
Likes: 2
From: Denver, Colorado
Tourer
Joined: Jun 2009
Posts: 433
Likes: 3
From: Northern Illinois
Find a cheap tool such as this one so you don't have to splice wires. The hardest part is getting the wires out of the connectors. You can do it with a small jewelers screwdriver but I would get the tool.
Intermediate
Joined: Nov 2009
Posts: 47
Likes: 0
Not hard, just a pain in the but playing with the connectors... Watch the you tube vidhttp://youtu.be/52clbzQ2reg and read the DIYs here...
I would suggest do one side at a time, draw a lil diagram with what colored wires go where... I have a streetbob and actually had excess wire that I stuffed back into the frame, so it was solderless job...
Good luck and a very worthwhile mod!!!
I would suggest do one side at a time, draw a lil diagram with what colored wires go where... I have a streetbob and actually had excess wire that I stuffed back into the frame, so it was solderless job...
Good luck and a very worthwhile mod!!!
Thread
Thread Starter
Forum
Replies
Last Post
TylerBoehm
Dyna Glide Models
30
Jan 19, 2014 11:20 PM
