Help!!
Ultimate HDF Member
Joined: May 2008
Posts: 6,642
Likes: 48
From: Ogden, UT
Is it cranking normally or slow? Have you checked the voltage on the battery? The ECM shuts down the ignition if the battery falls below 12v so it will not start. If your battery is low you may not be charging when running, this explains why it started a couple times then will not start any more. Initial problem may have been the sensor, but you may also have a charging or voltage Reg issue.
Thread Starter
|
6th Gear
Joined: Sep 2010
Posts: 13
Likes: 0
It is starting now but it is only firing on one cylinder. The Jackass that repainted my tank didn't clean out the tank and the fuel filter was completely clogged and the fuel pressure regulator was messed up. Now I am thinking I have a clogged fuel injector.
Thread
Thread Starter
Forum
Replies
Last Post
Master Dee
Ignition/Tuner/ECM/Fuel Injection
0
Feb 20, 2019 01:11 PM
