WON't START
Road Warrior
Joined: Nov 2008
Posts: 1,260
Likes: 5
From: Batesville Ga
Check for codes: http://www.ehow.com/how_5556684_pull...-davidson.html
I'm assuming you've checked all the fuses and they're good?
I'm assuming you've checked all the fuses and they're good?
Tourer
Joined: Nov 2011
Posts: 421
Likes: 4
From: Alabama
Crank position sensor.
Disconnect it & put a volt/ohm meter across the pins at connector. If resistance is infinate, that's it. As I recall (same thing happened to me), should be about 300 ohms.
BTW, no codes were set when mine failed ('04 Dyna).
Edit: Sorry, my mistake. In checking my records, the new CKP sensor checked out at 948 ohms resistance, not 300.
Disconnect it & put a volt/ohm meter across the pins at connector. If resistance is infinate, that's it. As I recall (same thing happened to me), should be about 300 ohms.
BTW, no codes were set when mine failed ('04 Dyna).
Edit: Sorry, my mistake. In checking my records, the new CKP sensor checked out at 948 ohms resistance, not 300.
Last edited by M&P340; Apr 23, 2012 at 06:54 AM.
Thread
Thread Starter
Forum
Replies
Last Post
