Panacea tail light question
Thread Starter
|
Road Captain
Joined: Jan 2013
Posts: 553
Likes: 1
From: South MS
Panacea tail light question
I've got a 13 street bob and am replacing the rear fender with the longer one and the panacea run/brake/turn light. I'm freaking terrible with electronics. Any tips/advice on how to hook the light up? I pulled everything apart but I can't figure out what goes where.
Road Warrior
Joined: Sep 2012
Posts: 1,252
Likes: 7
From: SLC, UT
I'd be surprised if there wasn't any kind of directions with the light... I'd take a look at those a little closer. Pictures always help too, and a thread search to see if others have done this before. Personally I haven't dealt with that light but I know with other run/turn/brake lights its just three wires that need connecting. Worse comes to worse, tie in your connections and see what works.
Ha, probably the best advice I've ever given
Not.
Ha, probably the best advice I've ever given
Not.
Thread Starter
|
Road Captain
Joined: Jan 2013
Posts: 553
Likes: 1
From: South MS
There are some directions with it but like I said I'm terrible with electronics. And I don't believe the wiring that comes with it is set up to be run on my bike. I did talk to the guys at southeast custom cycles and was told I need an 07 street bob harness.
Thread
Thread Starter
Forum
Replies
Last Post
Roadst1978
Electrical/Lighting/Alarm
2
Jun 4, 2015 10:15 PM
