Not sure if this is a stupid question but....

How do you tighten up the pushrod covers? Think I have one coming loose?

 

They are spring loaded

 

Cool.. Thank you
One seems to have a little more play than the other three..

 

How old is the bike? The o rings get hard and compressed over time. They’ll be a bitch and a half to put together with new rings but will be tight.

 

You don't have the Screamin' Eagle P-Rod cover wrench and Spring Tension tool set?

 

It's an 01 fxdl, cams, gears and adjustable pushrods were added three years ago.

 

If you didn’t do the work yourself, take them apart and check. Or live with it.

 

make a wise choice in selection o-ring material. i run the silicon type and been there since 2002. buna-n will work but will fail after a few years. go to a crane or hydraulic shop and get some from them as they will have the nitrile and viton as well.