ignition sensor plate
ignition sensor plate
somehow in cam replacement the sensor plate got damaged. the filler that is over the wires got peeled back and the ground wire got pulled out. any idea what that filler is? and anyone has seen this be repaired?
[IMG]
[/IMG]
[IMG]
[/IMG]
Stellar HDF Member
Joined: May 2009
Posts: 2,856
Likes: 127
From: Middle of Kansas
I think I would fill it with silicone sealer or bathtub calk. There should only be those three wires coming out and it looks like they are attached in the picture. A new one from Ronnie's HD is like $56.00. Maybe someone will chime in here with a better repair.
Elite HDF Member
Joined: Sep 2007
Posts: 4,468
Likes: 12
From: Bluffton, South Carolina
The sensor is over heating and melting the potting material. This material not only seals the unit it also helps in drawing heat out of it. Judging from the "witness marks on the plate you may have the timing a little off from where it was originally. This can make the engine run a little hotter. Time for a new one.
John
John
Last edited by miacycles; May 28, 2013 at 07:29 AM.
Thread
Thread Starter
Forum
Replies
Last Post
rottenbob
Ignition/Tuner/ECM/Fuel Injection
0
Apr 21, 2012 03:07 PM
