How to test ETS?
Thread Starter
|
Road Master
Joined: May 2014
Posts: 827
Likes: 59
From: Canada
How to test ETS?
Not having the HD break out box or scanalyzer tools is there a way to test the ETS on a 97 flh?
I have the manual, finally, but all I see is tests with the tools.
The code/light gave no info.
I have the manual, finally, but all I see is tests with the tools.
The code/light gave no info.
Last edited by johnod; Jun 25, 2014 at 05:51 PM.
Seasoned HDF Member
Joined: Oct 2007
Posts: 8,852
Likes: 2,493
From: Decatur, Alabama
Read through the "surging" thread in the EVO section. On about page 3 there is a chart showing voltage vs. temperature. You could hook up a voltmeter to the sensor and dunk it in a glass of water with a thermometer and a hot water kettle handy.
I might just try that the next time my ETS goes bad.
carl
I might just try that the next time my ETS goes bad.
carl
Thread Starter
|
Road Master
Joined: May 2014
Posts: 827
Likes: 59
From: Canada
Read through the "surging" thread in the EVO section. On about page 3 there is a chart showing voltage vs. temperature. You could hook up a voltmeter to the sensor and dunk it in a glass of water with a thermometer and a hot water kettle handy.
I might just try that the next time my ETS goes bad.
carl
I might just try that the next time my ETS goes bad.
carl
Thread Starter
|
Road Master
Joined: May 2014
Posts: 827
Likes: 59
From: Canada
So if I understand correctly resistance is checked between 2 terminals on sensor?
As I see it I can only measure this with the engine off.
I can't check resistance with voltage at the terminals.
As I see it I can only measure this with the engine off.
I can't check resistance with voltage at the terminals.
Last edited by johnod; Jun 26, 2014 at 05:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
