Dyno question
Thread Starter
|
Cruiser
Joined: May 2009
Posts: 108
Likes: 0
From: South Florida
Dyno question
Local stealor has a 3 pulls for $20 on the dyno. I hav a PCV and don't want it known by the stealor or my VIN "blacklisted by HD".
In any case, when they do a dyno pull, do they hook up any electronics to my ECM or just strap it down on the rollers and run it? Any reason for them to remove my seat and see the PCV since they are are not likely to notice my pluged O2 sensors...
In any case, when they do a dyno pull, do they hook up any electronics to my ECM or just strap it down on the rollers and run it? Any reason for them to remove my seat and see the PCV since they are are not likely to notice my pluged O2 sensors...
Road Warrior
Joined: Dec 2006
Posts: 1,530
Likes: 0
From: Diamond Bar, California
usually they just shove a AF sensor in the pipes.
that should be it. as for warranty, your bike will be out of it so fast that it almost dosent matter.
i had a HQ 95 kit installed at 2300 miles, the bike was almost out of basic, and 1year left on service contract, lost my tranny output seal six months in, dealer took care of it no questions asked, and I had done the last service on it with Redline shock proof!
that should be it. as for warranty, your bike will be out of it so fast that it almost dosent matter.
i had a HQ 95 kit installed at 2300 miles, the bike was almost out of basic, and 1year left on service contract, lost my tranny output seal six months in, dealer took care of it no questions asked, and I had done the last service on it with Redline shock proof!
Thread
Thread Starter
Forum
Replies
Last Post
wolfman5874
Sportster Models
5
Jun 25, 2016 08:14 AM
