O2 sensor question
Thread Starter
|
Stellar HDF Member
Joined: Apr 2005
Posts: 3,108
Likes: 9
From: Lincolnton, NC
O2 sensor question
I'll be helping a friend of mine with an exhaust removal / install next week. Do I need anything special to remove the O2 sensors or will an open end wrench do it? Didn't know if it required one of the specialty sockets.
Road Warrior
Joined: Nov 2007
Posts: 1,984
Likes: 7
An open end will work if you can get to them.
Sometime a problem especially clearance to swing the wrench.
sometime a closed end can work after you disconnect the wires and thread the wrench on.
Its all tight. and pipes are different.
Sometime a problem especially clearance to swing the wrench.
sometime a closed end can work after you disconnect the wires and thread the wrench on.
Its all tight. and pipes are different.
Last edited by Old Gunny; Jul 23, 2010 at 02:45 PM.
Outstanding HDF Member
Joined: May 2008
Posts: 2,543
Likes: 19
From: Ashland Ohio
Thread
Thread Starter
Forum
Replies
Last Post
