Barnet clutch spring install
Thread Starter
|
Tourer
Joined: Dec 2009
Posts: 440
Likes: 7
From: wisconsin
Barnet clutch spring install
I have to install heavy duty clutch spring on my 05 king . Do I need to pull primary cover and the entire clutch pak or can I pull the clutch cover and pull bolts out of diaphragm spring retainer and change the spring out.Tricks and Ideas are welcome by all. thanks jeff
Last edited by jurgie; Jul 30, 2012 at 02:42 PM.
Tourer
Joined: May 2010
Posts: 450
Likes: 2
Installed that spring on my 99 t/c ultra this past April. I was able to get the old one out, but after about 10 minutes of trying to get the new one in, I gave up and pulled the primary. Not that big of a deal to pull primary, and I was able to re-use the old gasket. When I removed gasket (carefully) I had a pan of water ready and let the gasket soak while changing the spring and adjusting the primary chain. Only trick I can think of that might help you get the new spring in without removing primary is to put the spring in the freezer over night. This might make it contract enough, but not sure.
Good luck.
Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
03 Softail
Primary/Transmission/Driveline/Clutch
3
Sep 15, 2007 11:22 AM
