I have been on the search for a crankshaft to use. I think I may have found one but am very confused by what each measurement each on should be. Please tell me if these look good or not.

Pinion shaft TIR .0005" at main bearing diameter, .0015" at the cam plate bushing diameter, sprocket shaft .001" at the main bearing diameter, when measured over "V" blocks.

 

Been reading more and if my understanding is correct this crankshaft is pretty much perfect

 

Yup, if it will stay that way?? Get it plugged or welded.

 

It has been trued pluged and welded by darkhorse

 

Just got back from a 3700 mile trip, New 107 build Darkhorse Crank ,Very Smooth .Plugged and welded ,Very happy with.

 

You are golden then. Nearly 10K miles on the last crank John and team worked over for me; very smooth runner in an all bore 107".