85 FXRS clearance issues
Thread Starter
|
Stage I
Joined: May 2017
Posts: 1
Likes: 0
From: Desert CA
85 FXRS clearance issues
Hello all I have been putting together an old evo motor for an fxrs I had to purchased heads for it since over the years they were MIA from PO so after scouring I found the correct ones they were decked .050 and had some valve work done but couldn't be sure on exactly what was done besides aftermarket springs the motor has an ev27 cam in it with stock length pushrods. I thought all would be cherry after reading other forums on the subject but when reassembling top end I have contact with the piston I used a .045 head gasket. My question is ebat would be the best way to go about this as far as adjustable pushrods, different pistons etc etc
Thank you all
Thank you all
Thread
Thread Starter
Forum
Replies
Last Post
