Part identification
Thread Starter
|
Stage III
Joined: May 2019
Posts: 3
Likes: 1
From: OK
Part identification
I'm needing someone to point me in the right direction here. I recently had an air filter backer plate bolt back out and got sucked all the way to the cylinder. The piston was broke in the process. I have it completely torn down, parts have all been completely cleaned and gone through the parts washer. I'm fixing to start re-assembly with new heads, pistons, rings, basically complete top end and oil pump while I'm there. My question is there's a little piece at the bottom of each cylinder right beneath the piston that comes to a point. There's two small bolts that hold it into the case on the lifter side. It looks to me to be something that catches oil to send it to the lifters, but I'm needing someone to let me know. When the piston shattered, it broke this piece as well and I'm needing to order one before assembly. Thanks in advance.
Intermediate
Joined: Sep 2015
Posts: 27
Likes: 27
From: Hinsdale, NH
Thread
Thread Starter
Forum
Replies
Last Post
Bagger_Vance
Engine Mechanical Topics
87
Jun 6, 2015 03:24 PM
